Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 397)

APS Error Messages
A–3
Display Message Recommended Action Description
BRIDGE DEVICE NOT ACTIVE Inability to attach to a KF3 while going
online with DF1 Full Duplex.
Retry the function.
BRIDGE DEVICE RESPONDED WITH
ERRORS
There is an error in the received packet
from the 1785ĆKA5 interface module.
Retry the function.
CANNOT EDIT THIS RUNG An attempt was made to edit a replaced
marked rung or modify a deleted marked
rung.
ReĆevaluate your edit attempt.
CANNOT INSERT A RUNG BETWEEN
AN IR PAIR
An attempt was made to insert, append,
or undelete a rung between an inserted
marked rung followed by a replaced
marked rung.
Move the cursor before or after the IR
pair and try to insert, append, or
undelete the next rung.
CANNOT MODIFY DATA TABLE SIZE
DURING ONLINE EDITING
Modification of data table sizes or
creation of new data tables cannot occur
while in an online editing session.
Go offline to change the data table sizes
and retry the function.
CANNOT MODIFY PARAMETER VIA
5/03 PROCESSOR'S CHANNEL 0
An attempt to change a node's owner,
the max. address, node address, or
baud rate of an SLC 5/03 while it was
communicating with APS over channel 0
was made.
Not allowed.
CANNOT MODIFY PROTECTED DATA
FILE DURING ONLINE EDITING
During an online editing session, an
attempt was made to modify data tables
that were constantly protected.
Not allowed. Go offline to either change
the data file protection and retry the
function, or edit the program offline.
CANNOT TRANSMIT - LOSS OF
COMMUNICATIONS
Either the communication interface
module has waited more than 10
seconds to gain access to the send
mailbox or APS has attempted to send a
packet before getting confirmation of the
previous send.
Retry the function.
CAUTION: INDIRECT ADDRESSES
MUST ALREADY EXIST AND BE
PROPERLY REFERENCED
An indirect address was entered into the
ladder program.
Ensure that the necessary data table
addresses are allocated for indirect
addressing.
CAUTION: REMOVING OUTPUT
REFERENCES LEAVES THE
OUTPUTS IN THEIR LAST STATE
Either 1) the Test Edits function key was
pressed and edits do exist in the ladder
program; or 2) an attempt to delete an
instruction was made.
Be aware that changes may result to the
output states when the new assembled
edits become active or when a restore is
performed via quick edits.
CAUTION: VERIFY STATE OF
OUTPUTS WITH DATA MONITOR
You directed APS to assemble all
existing online edits or a quick edit
program.
Be aware that changes may result to the
output states when the new assembled
edits become active or when a restore is
performed via quick edits.
CHANGE BINARY FILE TO
SEQUENTIAL BEFORE ENABLING
SHORT ADDRESSING
An attempt to enable short addressing
failed because the Binary File selection
is set to word/bit.
Change the Binary File selection to
sequential and then retry.