Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 267)

Configuring Your Processor for Online Communication
13–17
System Mode Driver Information for Channel 1
The following section describes the system modes available for channel 1 when
using either an SLC 5/03 or SLC 5/04 processor.
CHANNEL 0 CONFIGURATION
Current Communication Mode: SYSTEM
System Mode Driver: DF1 FULL-DUPLEX
User Mode Driver: SHUTDOWN
Write Protect: DISABLED
Mode Changes: DISABLED
Mode Attention Character: /1b
System Mode Character: S
User Mode Character: U
Edit Resource/File Owner Timeout: 60 (seconds)
Passthru Link ID: 1 (decimal)
CHANNEL 1 CONFIGURATION
System Mode Driver: DH+
Write Protect: DISABLED
Edit Resource/File Owner Timeout: 60 (seconds)
Passthru Link ID: 2 (decimal)
F2
UNDO
EDITS
Press a key for desired function
REM PROG no forces EDITS: NONE PROC Addr 1
Channel Configuration
F1
ACCEPT
EDITS
F4
CH0 SYS
CONFIG
F7
CH1 SYS
CONFIG
F10
SELECT
OPTION
F5
CH0 USR
CONFIG
Refer to the table on 13–9 for channel 1 configuration parameters.