21œ3, Sending a program — aps to aps, Offline config – Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 User Manual
Page 376: Press
Transferring Program Files
21–3
Transferring Programs Between Programming Terminals
Sending a Program — APS to APS
You can transfer a user program from the hard disk of the sending APS terminal to
the workspace of the receiving APS terminal using the send program function.
In the following example, node 0 is the sending APS terminal and node 3 is the
receiving APS terminal.
1.
Begin at the main menu on node 0, the sending APS terminal. Press
CONFIG
OFFLINE
CONFIG
SYSTEM
UTILITIES
F9
.
2.
Press
CONFIG
OFFLINE
CONFIG
PROGRAM
TRANSFER
F2
. The Who Listen display appears. The display shows you the
active nodes on the DH-485 network, indicated by asterisks next to the active
node addresses.
At this point, node 0, your sending APS terminal is not active on the network.
F2
RECEIVE
PROGRAM
Press a function key
Term. Addr: 0
Emulation: SLC 5/01
WHO LISTEN - Active Node Table
0
12
24
1
*
13
25
2
*
14
26
3
*
15
27
4
*
16
28
5
17
29
6
18
30
7
19
31
8
20
9
21
10
22
11
23
ESC exits
F6
EMULATE
5/01
F7
EMULATE
5/02
F4
SEND
PROGRAM
F8
EMULATE
5/03
F9
EMULATE
5/04