Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 411)

APS Error Messages
A–17
Display Message Recommended Action Description
PROCESSOR FAULTED An attempt was made while online to
change the processor mode to a state
not available while the processor is
faulted.
Correct the fault as specified, clear the
fault, and retry the function.
PROCESSOR LOCKED AND SOURCE
FILE NOT FOUND
The software is unable to find a
matching file in the archive file directory.
Lock bit (S:1/14) is set.
Place a copy of the program in the
processor in the current archive file
directory. Without a matching file, you
can only restore, clear processor, or do a
memory module transfer.
PROCESSOR MEMORY CORRUPTED The processor's memory is currently
invalid.
Clear the processor memory and retry
the function.
PROCESSOR NOT IN PROGRAM
MODE; CHANNEL
RECONFIGURATION NOT ALLOWED
A mode other than Remote Program
Mode is selected.
Change to Remote Program Mode and
retry the function.
PROCESSOR OUT OF MEMORY,
CHECK PROCESSOR MEMORY SIZE
While downloading, the processor
indicated that an address was received
outside of its memory address range.
Resave the file and retry the function.
PROGRAM LOAD ABORTED,
CORRUPT LADDER FILE
An attempt to load a program was
aborted.
Either 1) retry the function; 2) restart the
software; 3) reboot the PC; or 4) run
CHKDSK" from the DOS command
prompt.
PROGRAM OWNED BY ANOTHER
PROGRAMMING DEVICE
A programming device cannot monitor a
ladder program that another
programming device currently has
locked for an online editing session.
Determine why another node has explicit
access.
PROGRAMMER IS OFFLINE,
FUNCTION NOT AVAILABLE
An attempt to view or copy to an online
multiĆpoint list was made when an online
processor does not exist.
Informational message. Retry the
function at a later time.
PROCESSOR PROGRAM
INCOMPATIBLE WITH PROGRAMMER
The user program in the processor is
incompatible with this version of APS.
Install the correct version of APS and
retry saving the program.
PROGRAM OWNER ACTIVATED BY
ANOTHER PROGRAMMING DEVICE
A programming device, other than the
one generating this message has
initiated an online editing session.
Informational message. Retry the
function at a later time.
PROGRAM OWNER ACTIVE Another programming device owns the
processor.
Find the programming device on the link
and clear its ownership. Retry the
function.
PROGRAM TRANSFER NOT
SUPPORTED FOR CURRENT ONLINE
CONFIGURATION
The current device does not support
program transfers.
Select either a 1747ĆPIC (DHĆ485),
1784ĆKR (DHĆ485), or a KF3/KE
(FullĆDuplex).
PROGRAM WAS SAVED WITH ERROR
- CANNOT TRANSFER FILE
Errors were saved with the program. You
cannot download or transfer the program
to a processor.
Correct the errors in the program and
resave. Retry the function.