Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 229)

Configuring Your Programming Device for Online Communication
11–35
Example Configuration: DH+ to DH-485 via 1785-KA5 Gateway
SLC 5/03 processor
Node 7
(octal)
APS 6.0 or later
Node 77
(octal)
Node 2
(octal)
CH0
Node 1
(octal)
DH+
Link ID=1
57,600 baud
DHĆ485
Link ID=2
19,200 baud
KA5
Current Device 1784-KT (DH+ Bridged)
F1 Bridge Type DH+ to DH485 via 1785 KA5 Gateway
Terminal Name
Terminal Address
77 (octal)
Baud Rate 57600
F5 Remote SLC Node Addr. 1 (decimal)
F6 KA5 DH+ Address 7 (octal)
F7 KA5 DH485 Link ID 2 (decimal)
IRQ 5
Board/Memory Address 001011
F8 Curr. Interchange Port 1
F9 Save to File
F9
Press a function key
SAVE TO
FILE
ESC exits/Alt-U aborts changes
ONLINE CONFIGURATION
F8
NEXT
PORT
F5
REMOTE
ADDRESS
F2
SELECT
DEVICE
F1
SELECT
BRIDGE
F6
KA5 DH+
ADDRESS
F7
KA5 485
LINK ID
Function Key Description
[F1] Select Bridge Type
Allows you to select the desired bridge type: DH+ to DH+ via
two 1785ĆKA, DH+ to DH485 via 1785 KA5 Gateway, PI
routing, or DH+ to Channel 0 via 5/04 passthru.
[F2] Select Device
Toggles between the selected device driver and the device
driver selection menu.
[F5] Remote SLC Node Address
Allows you to enter the SLC address. Valid range is 1–31
decimal. The default is 1.
[F6] KA5 DH+ Address
Allows you to enter the KA5 DH+ address. Valid range is 0–77
octal. The default is 7.
[F7] KA5 DHĆ485 Link ID
Allows you to enter the KA5 DH+ link ID. Valid range is 0–15
decimal. The default is 2.
[F8] Next Port
Allows you to select the port number where the interface card
is installed. Valid range is 1–8. The default is 1.
[F9] Save to File Saves the selected parameters to a user file.