Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 41)

Preface
Advanced Programming Software User Manual
3–2
Configuration Options
The following pages show the factory default settings. If your system has been
previously configured, the displays may vary.
From the main menu, press
CONFIG OFFLINE
CONFIG
SYSTEM
CONFIGR
F6
to view the System Configuration display.
F1 Editor Highlighting Style: REVERSE
F3 Color Selection: MONOCHROME
F4 Address
F5 Printer Configuration
F6 System Startup State: MAIN MENU
F7 Define Directory Paths
F8 Monitor M0/M1 Addresses: DISABLED
F9 Save Configuration
F1 F6 F7 F3 F5 F9
EDITOR
HILIGHT
SYSTEM
STARTUP
DEFINE
DIR
COLOR
SELECT
PRINTER
CONFIG
SAVE
CONFIGR
Press a function key
SYSTEM CONFIGURATION
ESC exits/Alt-U aborts changes
F8
M0/M1
MONITOR
F4
ADDRESS
Editor Highlighting Style
Function key [F1], Editor Highlight toggles the editor highlighting style between
REVERSE and INTENSIFY. These two options are for monochrome and LCD
monitors only. They do not affect the color display monitors.
Reverse (Default Option – Preferred Option When Using an LCD Monitor)
•
Cursor is shown as a flashing area (the instruction, rung location, or power rail
location alternately appears/disappears).
•
True instructions are shown as reversed screen areas.
•
A true instruction at the cursor location is shown as a reversed screen area (true)
and flashing (cursor).
•
Enabled forces are shown as On or Off in a reversed screen area.