Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 382)

Transferring Program Files
21–9
Receiving a Program — APS to APS
Using the receive function, you can transfer a user program from the workspace of
an APS terminal to the hard disk of your APS terminal.
In the following example, node 0 is the sending APS terminal, node 3 is the
receiving APS terminal.
1. Begin at the main menu on node 3, the receiving APS terminal. Press
CONFIG OFFLINE
CONFIG
SYSTEM
UTILITIES
F9
.
2. Press
CONFIG OFFLINE
CONFIG
PROGRAM
TRANSFER
F2
. The Who Listen display appears. The display shows you the
active nodes on the DH-485 network, indicated by asterisks next to the active
node addresses.
At this point, node 3, your receiving APS terminal is not active on the network.
F2
RECEIVE
PROGRAM
Press a function key
Term. Addr: 0 Emulation: SLC 5/01
WHO LISTEN - Active Node Table
0 * 12 24
1 * 13 25
2 * 14 26
3 15 27
4 * 16 28
5 17 29
6 18 30
7 19 31
8 20
9 21
10 22
11 23
ESC exits
F6
EMULATE
5/01
F7
EMULATE
5/02
F4
SEND
PROGRAM
F8
EMULATE
5/03
F9
EMULATE
5/04
For this example, you are transferring program file TRANSFER that is written
for an SLC 5/02 processor.
Note You must configure the receiving APS terminal to emulate the type of processor that
the program is written for. The default emulation is for the SLC 5/01 processor.