Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 298)

Monitoring Controller Operation
16–5
2. Enter the type of program you want to edit by pressing either
CONFIG OFFLINE
CONFIG
OFFLINE
PROCSSR
F1
or
CONFIG OFFLINE
CONFIG
OFFLINE
DISK
F3
. If you are using an SLC 5/02 processor and the file already exists,
the message: OVERWRITE FILE is displayed. Press
CONFIG OFFLINE
CONFIG
YES
F8
if you want
to overwrite the file and continue, or press
CONFIG OFFLINE
CONFIG
NO
F10
and choose a different
program to edit.
If you are using an SLC 5/03 or SLC 5/04 processor, you can press
CONFIG OFFLINE
CONFIG
ONLINE
EDIT
F7
and access the editing functions. If the operating system in your processor is
capable of performing more advanced editing operations than your program
indicates you can accept the advanced functions and your program will be
updated.
Choose the processor program if you want to retain the current processor data.
When you upload the ladder logic, all of the current data is captured.
Choose the disk program if you want to begin from a “default” base, such as
with timers and counters. This option allows you to edit the data on the hard
disk.
If you choose DISK PROGRAM and the disk file contains a password, the
system prompts you to enter a password. If the processor password does not
match the disk file password or the master password, the message:
WARNING,
PROCESSOR PASSWORDS(S) DO NOT MATCH DISK FILE
PASSWORD(S) is displayed.
This message warns you that if the disk file is restored to a processor, the
processor takes on the disk file password.