Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 311)

Preface
Advanced Programming Software User Manual
16–18
Counter Data File (C5:)
The display below shows the counter data file. The cursor is on the Count Up
Enable bit (CU) of counter C5:0, address C5:0/CU. There are three counters in the
file.
Press a function key
C5:0/CU =
REM PROG
no forces formatted decimal addr PROC Addr 1
F7 F5
NEXT
FILE
SPECIFY
ADDRESS
F8
PREV
FILE
address CU CD DN OV UN UA PRE ACC
C5:0 0 0 0 0 0 0 3601 1602
C5:1 0 0 0 0 0 0 24 15
C5:2 0 0 0 0 0 0 0 0
Control Data File (R6:)
The display below shows the control data file. The cursor in the display area is on
the enable bit of control element R6:0, address R6:0/EN. In the control element
there are eight control bits. The fixed controller and SLC 5/01 processor have six
control elements. The SLC 5/02, SLC 5/03, and SLC 5/04 processors have eight
control elements.
Press a function key
R6:0/EN =
REM PROG
no forces formatted decimal addr PROC Addr 1
F7 F5
NEXT
FILE
SPECIFY
ADDRESS
F8
PREV
FILE
address EN EU DN EM ER UL IN FD LEN POS
R6:0 0 0 0 0 0 0 0 0 0 0
R6:1 0 0 0 0 0 0 0 0 0 0
R6:2 0 0 0 0 0 0 0 0 0 0
R6:3 0 0 0 0 0 0 0 0 0 0
R6:4 0 0 0 0 0 0 0 0 0 0
Note The IN bit is the Running bit (RN) for ASCII instructions.