Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 153)

Protection
8–11
Fixed and SLC 5/01 Processor
The output file is always statically protected. You cannot alter the output data file
while in the REM Run mode using the communication channels. However, all other
data table files are unprotected.
SLC 5/02 Processor
You can choose to statically protect your data table files at the time you save your
program. When you press [F2], Save from the Program Directory display, the
following screen appears:
File Name: EXAMPLE
F1 Single Step Test DISABLE
F3 Index Across Files: DISALLOW
F4 File Protection OUTPUTS
F6 Future Access: ALLOW
ESC exits
F1 F6 F3 F4 F8
SINGLE
STEP
FUTURE
ACCESS
INDEX
CHECKS
FILE
PROTECT
YES
FILE ALREADY EXISTS
Overwrite File?
offline SLC 5/02 File EXAMPLE
F10
NO
Apply protection to your data table file by pressing
CONFIG OFFLINE
CONFIG
FILE
PROTECT
F4
.
This key [F4], toggles between:
•
Output - only the output file is statically protected (default).
•
All - all files are statically protected.
•
None - no files are protected.
For more information on saving your file(s), see chapter 9.