Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 17)

Preface
Advanced Programming Software User Manual
1–10
CONFIG.SYS File
Your CONFIG.SYS file must contain the following statements:
FILES=40 ( If running in a windows environment, set FILES
w
46 .)
BUFFERS=40
Note These are minimum values. If your CONFIG.SYS file contains FILES and
BUFFERS statements with greater values, there is no need to change the file. Be
aware that these statements may conflict with the
CONFIG.SYS requirements for
other software packages you have installed on your programming terminal.
Locating the Software’s Serial Number
During the installation process you are asked for the serial number of your software.
The serial number you enter is used to personalize the software.
The serial number is not found on the disks. It can be found in several places
though. These are:
•
the software registration card
•
the registration change card
•
the outside of the shipping carton
Note If you enter the serial number incorrectly or enter the wrong serial number and
accept the entry, you will be unable to correct this situation later. Therefore, verify
your serial number carefully, before committing your work.
Installing the Software
To install the software, do the following:
1. Insert the diskette labeled Disk 1 into the appropriate disk drive (either drive A
or drive B). For this example, we are using drive A.
2. Exit to DOS.
3. Type: A:INSTALL , then press [ENTER] .
4. During the installation process, instructions appear on the screen to prompt you
through the procedure. Follow the instructions and type in the information
requested.