Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 277)

Preface
Advanced Programming Software User Manual
14–4
Restoring a File
The figure below shows an APS programming terminal and an interconnected
processor. In the following example, the file
EXAMPLE replaces the online
processor file ( SEQUENCE ). In other words, EXAMPLE is restored.
TERMINAL
PROCESSOR 1
OFFLINE
PROCESSOR
FILE
SEQUENCE
ONLINE
PROCESSOR
FILE
SEQUENCE
ARCHIVE
EXAMPLE
SEQUENCE
TOGGLE
Workspace Hard Disk
Before going online, check to make sure that a valid program exists in your
processor.
1. Begin at the main menu and press
CONFIG OFFLINE
CONFIG
ONLINE
F1
. The program directory of the
online processor file SEQUENCE appears:
F1 F2 F6 F7 F3 F4 F8
PROCSSR
FUNCTNS
SAVE
RESTORE
CREATE
REPORTS
FILE
OPTIONS
RETURN
TO MENU
CHANGE
LINK ADR
MONITOR
FILE
Press a key, enter file number or file name
REM PROG L532 Series C Rev.2 PROC Addr 1
F5
WHO
ACTIVE
F9
DATA
MONITOR
F10
MEMORY
MAP
FILE PROTECTED NAME TYPE SIZE (words)
0 system 74
1 reserved 0
2 ladder 48
PROGRAM DIRECTORY FOR PROCESSOR: SEQUENCE