Offline config – Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 User Manual
Page 373
Using Memory Modules (EEPROMs and UVPROMs)
20–9
6.
For this example 8k bytes is used. Press
CONFIG
OFFLINE
CONFIG
8K
BYTES
F1
. The message line displays
. . .
Working
. . . momentarily while the conversion is processing. If the
conversion is successful, the message:
CONVERSION SUCCESSFUL –
8922 BYTES CONVERTED
is displayed. Press any key to return to the
previous menu.
Notice that an asterisk appears before file
EXAMPLE
. This indicates the file has
been successfully converted to hexadecimal.
When you exit the APS software, the hexadecimal file can be exported or
copied to your PROM programmer using DOS commands or your UVPROM
programmer software.
If you subsequently edit and save file
EXAMPLE
and want to convert the edited
file to hexadecimal, you will have to overwrite the previous version of the hex
file. When you attempt to overwrite the file, the message:
Overwrite
existing .HEX file?
is displayed.
7.
If you wish to overwrite the existing file, press
CONFIG
OFFLINE
CONFIG
YES
F8
. If you do not wish
to overwrite the existing file, press
CONFIG
OFFLINE
CONFIG
NO
F10
.
8.
At this point you can either attempt another conversion or go back to the system
utility menu by pressing
[ESC]
. If you press
[ESC]
again, the main menu
appears.