Offline config, Station diagnostics – Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 User Manual
Page 243

Using WHO
12–9
If terminal 0 exits APS or is disconnected from the network, terminal 1 can use
the Clear Owner function to clear terminal 0’s ownership of a node. Terminal 1
then has access to the node and can claim ownership.
3.
To clear ownership, cursor to the desired node and press
CONFIG
OFFLINE
CONFIG
CLEAR
OWNER
F4
. To
succeed you must either be the current owner or the current owner cannot be
active.
Station Diagnostics
The Station Diagnostics function allows you to monitor network activity and to
display individual node diagnostics. Access this function by pressing
CONFIG
OFFLINE
CONFIG
STATION
DIAGS
F2
at
the Who Active display. The following display appears:
Network Diagnostics:
Node Diagnostics
Total Nodes
3
Node
0
Max. Node Address
31
Device Type
5/02
Messages Transmitted
21
Firmware Revision
1
Messages Received
21
Firmware Series
C
Retries
0
Mode
Retry Limit Exceeded
0
Major Fault
0000H
Bad Messages Received
0
Program Name
Nak No Memory Sent
0
Forces
Nak No Memory Rcvd
0
F2
CLEAR
COUNTER
Press a key for desired network function
WHO ACTIVE - Active Station Status
ESC exits
Note that the only option available at this display is to clear counters. This
function resets all of the network diagnostics fields to zero. The counters wrap
if they are not cleared.