Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 249)

Using WHO
12–15
DH+ WHO Listen
The DH
+
WHO Listen display shows you active node addresses. You cannot
change a node’s status from this display.
Access the DH
+
WHO Listen display by pressing [F4] WHO Listen. If your system
is configured using a 1784-KT (DH
+
direct) interface card, only the processor is
indicated in the WHO Listen display. If your system is configured using
Interchange DH
+
with a 1784-KT interface card and the cfg_kt.ini file initialized,
then the WHO Listen display appears as follows:
Press a function key
F2
Online
Configr
DH+ Network Menu
Rockwell Software Incorporated, Copyright 1989-1995
All Rights Reserved
A 6200 Series Software Product
WHO LISTEN - Active Node Table
0 10 20 30 40 50 60 70
01000000 00000000 00000000 00000000 00000000 00000000 00000000 00000001
Processor location
Terminal location
An active node is represented by a one and a non-active node is represented by a
zero. Note that the display is presented in octal.