Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 260)

Preface
Advanced Programming Software User Manual
13–10
Parameter
Description
Parameter -
Channel 0 SLC 5/03 OS300
SLC 5/03 OS301, OS302 and
SLC 5/04 OS400, OS401
Current
Communication
Mode
This field defaults to System
and is nonĆselectable.
Toggles between System and User. The
default is System.
System Mode Driver
Toggles between DF1
HalfĆDuplex Slave, DF1
FullĆDuplex, DHĆ485, and
Shutdown. The default is DF1
FullĆDuplex.
Toggles between DF1 HalfĆDuplex
Slave, DF1 HalfĆDuplex Master, DF1
FullĆDuplex, DHĆ485 Master and
Shutdown. The default is DF1
FullĆDuplex.
User Mode Driver Reserved
Toggles between Generic ASCII and
shutdown. The default is Generic ASCII.
Write Protect
Toggles between Enabled and
Disabled. The default is
Disabled.
Toggles between Enabled and Disabled.
If enabled, the channel ignores incoming
write commands. The default is
Disabled.
Mode Changes Reserved
Toggles between Enabled and Disabled.
The default is Disabled.
Mode Attention
Character
Reserved
Allows you to enter any hexadecimal
value or ASCII printable character. The
default is \1b.
System Mode
Character
Reserved
Allows you to enter any hexadecimal
value or ASCII printable character. The
default is S.
User Mode
Character
Reserved
Allows you to enter any hexadecimal
value or ASCII printable character. The
default is U.
Edit Resource/File
Owner Timeout
This is the communication
timeout period (application
layer). Valid range is 1-65535
seconds. The default is 60.
This is the communication timeout
period (application layer). Valid range is
1-65535 seconds. The default is 60.
Passthru Link ID Not Applicable Valid range is 0-65534.
System Mode Driver Information for Channel 0
Each type of system mode driver has a channel configuration screen associated with
it that allows you to select the configuration parameters. The following section
describes the system modes available with channel 0 when using either an SLC 5/03
or SLC 5/04 processor. Use
[F10] Select Option to change the
configuration displays.