Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 396)

Preface
Advanced Programmming Software User Manual
A–2
General Information
Often, APS errors are caused due to incorrect configuration of your personal
computer. Verify that your system is configured as follows:
•
CONFIG.SYS file should be set as: FILES=40 (or 46 when running in
Windows) ; BUFFERS=40.
•
AUTOEXEC.BAT file should include: C:\DOS\SHARE.EXE
•
Extended/expanded memory manager must be LIM 3.2 or higher.
APS runs with most Terminate and Stay Resident (TSR) programs. However, some
TSR programs causes APS to operate erratically. Therefore, we recommend that no
TSR programs execute while APS is running. If you choose to forego this
recommendation and you experience difficulties, edit and mark out your TSRs one
by one until you find the offensive TSR. This also applies to device drivers (other
than extended/expanded memory managers).
Display Message Description Recommended Action
ADDRESS OUT OF RANGE The specified device you are trying to
communicate with is out of memory.
Check the device and your command;
retry the function
ALL REQUIRED OPERANDS HAVE
NOT BEEN ENTERED
While programming an instruction an
operand(s) was left out.
Enter all operands and retry the function.
ATTEMPTING TO RESTORE FILE TO
PROCESSOR, PROCESSOR MUST BE
IN PROGRAM MODE
During a restore, or when attempting
switching from offline editing to online
monitoring, the offline program was not
downloaded because the processor was
not in program mode.
Place the processor in program mode
and retry the function.
BAD REPLACE STRING The text entered for a replace string
does not have the correct syntax.
Check the syntax and correct if
necessary. Retry the function.
BAD SEARCH STRING The text entered for a search string does
not have the correct syntax.
Check the syntax and correct if
necessary. Retry the function.
BECAUSE IR PAIRS CANNOT BE
SEPARATED, THE EXTRA RUNG HAS
ALSO BEEN SELECTED
The last rung selected belongs to an IR
pair.
None required.
BOTH SOURCE OPERANDS CANNOT
BE CONSTANTS
Source A and Source B operands are
both constants.
Change one of the operands to an
address. Retry the function.
BRIDGE DEVICE NO LONGER
RESPONDING
While online with DF1 Full Duplex
through a KF3 (with or without a
modem) a disconnection or hangup
occurred.
Retry the function.