Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 348)

The Multi-Point Function
18–3
The Multi-Point List Menu
You can access the multi-point list when online or offline from the monitor file
display by pressing
CONFIG OFFLINE
CONFIG
MULTI
F4
POINT . The following screen appears:
F10
Press a function key
REM PROG no forces EDITS: NONE PROC Addr 1
EXIT
F3
TOGGLE
STATE
F5 F6
VIEW
OFFLINE
COPY TO
OFFLINE
F1
EDIT
FIELDS
F2
DISPLAY
SYMBOLS
F7
FORCE
ESC exits
MULTIPOINT
POINT ADDRESS STATE DESCRIPTION
0 I:2.0/15 1 Gate OPEN
1 N7:0/12 0 P/N is even
2P O:3.0/0 1 Motor STARTED
3P I:1.0/3 1 LS1 Actuated
4 B3/3 0 target file=15
5P B3/4 1 barcode data OK
6 O:3.0/2 1 Diverter RIGHT
7 I:2.0/0 0
8 I:2.0/1 1 Overtravel RIGHT
9 I:2.0/2 0
10P I:2.0/3 1 Overtravel DOWN
11 B3/10 0 Machine Idle
12 B3/11 0 Normal Storage
13 O:3.0/12 0 Laser OFF
Point: The number of the entry in the multi-point list. If the entry is protected
(read-only), the letter P appears to the right of the entry number. See page 18–4 for
more information on protection.
Address: Displays the address within the data table that is being monitored.
State: Shows the current state of the monitored bit (i.e., 0, 1, 0FON, 1FON, 0FOF,
1FOF, FON, FOF).
Description: Displays a description of up to 16 characters. Separate descriptions
can be entered for the ON and OFF states. The SLC 5/03 and SLC 5/04 processors
store these descriptions in the controller’s memory.