Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 362)

The Force Function
19–11
Monitor Output Force Display
To install and monitor output data file forces, press
CONFIG OFFLINE
CONFIG
MONITOR
OUTPUTS
F10
.
Press a key or enter force value
O:0/0 =
REM RUN forces ENABLED binary data decimal addr PROC Addr 1
F7 F5
ENABLE SPECIFY
ADDRESS
F8
DISABLE
F1
OFF
F6
DATA
MONITOR
F2
ON
F3
REMOVE
F4
REMOVE
ALL
address 15 data 0 address 15 data 0
O:0 .... ...1
The output force table shows that O:0/0 is forced ON.
Data Monitor
The output data file can be accessed from the previous output force display. Press
CONFIG OFFLINE
CONFIG
DATA
MONITOR
F6
. The following display appears:
Press a key or enter value
O:0/0 =
REM RUN forces ENABLED binary data decimal addr PROC Addr 1
F7 F5
NEXT
FILE
SPECIFY
ADDRESS
F8
PREV
FILE
F1
CHANGE
RADIX
F6
FORCE
MONITOR
address 15 data 0 address 15 data 0
O:0 0000 0000
The output data file indicates that O:0/0 is false. The data file bit is unaffected by
the forced output.
You can return to the monitor input force display by pressing
CONFIG OFFLINE
CONFIG
FORCE
MONITOR
F6
.