Preface, Receiving a program — hht to aps, Offline config – Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 User Manual
Page 391
Preface
Advanced Programming Software User Manual
21–18
Receiving a Program — HHT to APS
You can transfer a user program from the HHT to the APS terminal using the
receive program function. In the following example, node 0 is the receiving APS
terminal, node 4 is the sending terminal.
1.
Begin at the main menu on node 0, the receiving APS terminal. Press
CONFIG
OFFLINE
CONFIG
SYSTEM
UTILITIES
F9
.
2.
Press
CONFIG
OFFLINE
CONFIG
PROGRAM
TRANSFER
F2
. The Who Listen display appears. The display shows you the
active nodes on the DH-485 network, indicated by asterisks next to the active
node addresses.
3.
The default emulation is for an SLC 5/01 processor. If the program in the HHT
is for an SLC 5/02 processor, the APS terminal must be configured for an SLC
5/02 processor. Press
CONFIG
OFFLINE
CONFIG
EMULATE
5/02
F7
.
F2
RECEIVE
PROGRAM
Press a function key
Term. Addr: 0
Emulation: SLC 5/01
WHO LISTEN - Active Node Table
0
*
12
24
1
*
13
25
2
*
14
26
3
15
27
4
*
16
28
5
17
29
6
18
30
7
19
31
8
20
9
21
10
22
11
23
ESC exits
F6
EMULATE
5/01
F7
EMULATE
5/02
F4
SEND
PROGRAM
F8
EMULATE
5/03
F9
EMULATE
5/04