Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 409)

APS Error Messages
A–15
Display Message Recommended Action Description
MUST BE FIRST INSTRUCTION IN
THE FILE
The required instruction must be the first
instruction in the ladder file.
Change the location of the instruction to
be the first instruction in the ladder file.
NAK RETRIES EXHAUSTED DF1 Full Duplex data is not being
received by the KF3.
Check for noise and retry the function.
NO ACCESS OR PRIVILEGE
VIOLATION
The device is not in the program mode. Change the mode to program mode and
retry the function. If this message still
appears, default the processor to its
original settings.
NO EDITS IN PROCESSOR The Test Edits function key was pressed
and no edits exist in the ladder program.
Retry the function.
NO ENTRIES HAVE BEEN MADE INTO
THE ADDRESS DATABASE
While documenting a program the
function key `next address' was pressed
and no address comments exist.
Informational message. No action
necessary.
NO ENTRIES HAVE BEEN MADE INTO
THE SYMBOL DATABASE
While documenting a program the
function key `next symbol' was pressed
and no symbols exist.
Informational message. No action
necessary.
NO MEMORY LEFT Either 1) there is no available hard disk
space to perform the current operation;
or 2) there is insufficient computer RAM
memory.
1) Review all files on the hard drive and
remove all unnecessary files; 2) remove
any TSRs that may be taking memory
space; 3) verify your disk validity by
running CHKDSK" from the DOS
command prompt. We recommend
525K bytes available for APS 3.01,
550K bytes available for APS 4.0,
250K bytes available for APS 5.0, and
300K bytes available for APS 6.0.
NO PROGRAMMABLE MEMORY
MODULE IN PROCESSOR
Either 1) there is no memory module in
the processor; or 2) the memory module
is write protected, or 3) the memory
module that is installed is the wrong size
for the processor.
Install a memory module in the
processor.
NO ROOM IN BUFFER Either 1) the software attempted to send
out a message too large to transmit; or
2) another device is trying to send a
message to the software.
Check the device for problems and retry
the function. If this does not work contact
your RSI representative.
NO SPACE FOR TAB INSERT HERE The text storage for a rung, address, or
instruction comment has been
exceeded.
Informational message. No action
necessary.
NO SYMBOL TO REMOVE Invalid symbol name was entered. Enter a valid symbol name.
NOT A DIRECT ADDRESS, PLEASE
ENTER A DIRECT ADDRESS
An attempt to enter the Data Monitor
was made, but the cursor was on an
instruction with an indirect address.
Enter an address for a data table.