Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 354)

The Force Function
19–3
Applying Force File Protection (SLC 5/03 and SLC 5/04 Processors)
Applying force file protection applies to SLC 5/03 and SLC 5/04 processor files.
Force file protection must be selected before performing a Test Edits or Program
Save when using SLC 5/03 and SLC 5/04 processors. If you attempt to enable
forces of an already force protected file, the message:
FORCE STATE CANNOT
BE MODIFIED DUE TO FORCE FILE PROTECTION is displayed.
Forcing External Input Data File Bits
Installing forces on input data file bits only affects the input force table. However,
when forces are enabled the input data file and the program logic are also affected.
The effects on the program logic of installed and enabled forces can be seen in both
the REM Run and any of the REM Test modes.
The following is the online Monitor File display for a processor file. The status line
indicates that the processor is in the REM Run mode and no forces exist. The cursor
is located on instruction I:0/1 in rung 0.
Press a function key
(file 2, rung 0)
REM RUN
no forces PROC Addr 1
F2
CONFIG
DISPLAY
F3
EXIT
F6 F7
SEARCH GENERAL
UTILITY
F9
FORCE
F8
DATA
MONITOR
F1
CHANGE
MODE
( )
O:0
0
END
( )
B3
10
( )
B3
11
] [
B3
11
]/[
B3
12
]/[
B3
10
]
I:0.
1
( )
B3
12
] [
B3
11
] [
I:0
1
]/[
B3
10
]
I:0.
1
] [
B3
11
F10
EDIT
F5
DOCUMNT