Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 414)

Preface
Advanced Programmming Software User Manual
A–20
Display Message Recommended Action Description
UNABLE TO DELETE PROGRAM FILE
DURING ONLINE EDITING
Program file deletion is not allowed
during an online editing session.
Go offline to delete program files.
UNABLE TO SUCCESSFULLY READ
ARCHIVE FILE
While reading the processor image in
the archive file a failure occurred.
Verify your disk validity by running
CHKDSK" from the DOS command
prompt. On successful completion retry
the function.
UNMATCHED MCRS During program save or test edits an
unpaired MCR instruction was detected.
Verify that all MCRs occur in pairs. Retry
the function.
USER PROGRAM INCOMPATIBLE
WITH PROCESSOR OPERATING
SYSTEM
The current user program is
incompatible with the selected
processor.
Change the processor and attempt to
restore the user program again.
WARNING: EXPRESSION TOO LONG
TO DISPLAY WITHOUT SYMBOLS
An expression was imported by the APS
Import/Export utility, but it will exceed the
maximum 255 character length if
symbolic addressing is disabled.
Ensure symbolic addressing is enabled.
WARNING: INSTRUCTION PROVIDES
NO FUNCTION; BOTH CHANNELS
ARE DISABLED
For a SVC and REF using an SLC 5/03
both channels are programmed as
disabled.
Informational message. No action
necessary.
WARNING: PROGRAM IS READĆONLY,
NO CHANGES WILL BE SAVED
A read only program has been opened. Informational message. No action
necessary.
WARNING: PROCESSOR NOT IN
PROGRAM MODE, DATA TABLE
VALUES MAY BE CHANGING
An attempt is being made to upload a
program while in the REM Run mode.
Informational message. No action
necessary.
WHO NOT SUPPORTED FOR
CURRENT ONLINE CONFIGURATION
Who Active and Who Listen are not
supported by the current configuration.
Informational message. No action
necessary.