Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 197)

Configuring Your Programming Device for Online Communication
11–3
Using Non-INTERCHANGE Drivers
If INTERCHANGE is running for a device that you want to use a
non-INTERCHANGE driver for, do the following:
1. Exit APS.
2. If necessary, change the drive specifier to the drive where the software is
installed (typically C). To do this, type:
C: and press [ENTER] .
3. If you are using the default directory, at the DOS prompt, type:
CD \IPDS\ATTACH\SLC500 and press [ENTER] .
If you specified a different directory path, change to that directory and press
[ENTER] .
4. Make sure the Windows drivers are stopped:
If your AUTOEXEC.BAT contains this command: \ABIC\BIN\ABICRUN,
type
ABIC\BIN\ABICSTOP .
If your AUTOEXEC.BAT contains this command: \RSI\IC\BIN\ABICRUN,
type
RSI\IC\BIN\ABICSTOP .
5. Run APS without INTERCHANGE by typing: IT and press [ENTER] .
Now you can configure the non-INTERCHANGE driver that you want, connect
to the processor online, and enter the DH+ Who Active screen.
Available Interface Cards
The table that follows lists the interface cards you can use with your system.
Note Refer to the documentation accompanying the interface cards for information on
proper installation procedures.