Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 263)

Configuring Your Processor for Online Communication
13–13
Parameter Description
Message Retries
Allows you to select the message retries value. The valid range is
0-255. The default is 3.
Control Line
Toggles between No Handshaking, HalfĆDuplex with continuous
carrier, and HalfĆDuplex without continuous carrier. The default is
No Handshaking.
EOT Suppression Toggles between Yes and No. The default is No.
DF1 Half-Duplex Master Channel 0 Configuration
When the system mode driver is DF1 Half-Duplex Master for channel 0, the
following screen is displayed:
Communication Driver: DF1 HALF-DUPLEX MASTER
Diagnostic File: Reserved
Baud Rate: 19200 Parity: NONE
Stop Bits: 1 Station Address: 254
Duplicate Detect: DISABLED Error Detect: CRC
ACK Timeout [x20 ms]: 65535 RTS Off Delay [x20 ms]: 65535
Message Retries: 255 RTS Send Delay [x20 ms]: 65535
Pre-send Time Delay [x1 ms]: 65535
Control Line: HALF-DUPLEX WITHOUT CONTINUOUS CARRIER
Polling Mode: MESSAGE BASED (DO NOT ALLOW SLAVE TO INITIATE MESSAGES)
Priority Polling Range – Low:100
Normal Polling Range – Low: 100
Priority Polling Range – High:100 Normal Polling Range – High: 100
Reply Message Wait Time [x20ms]: 65535 Normal Poll Group Size: 255
F2
UNDO
EDITS
Press a key for desired status function
REM PROG no forces EDITS: NONE PROC Addr 1
Channel 0 System Mode Configuration
F1
ACCEPT
EDITS
F9
CHANNEL
STATUS
F10
SELECT
OPTION