Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 399)

APS Error Messages
A–5
Display Message Recommended Action Description
DATABASE READ ERROR A DOS file read error occurred or a
program documentation file was altered.
Check your CONFIG.SYS file for proper
set up. (FILES=30 and BUFFERS=30.)
Verify that no TSR programs are
interfering with APS. If changes are
made, you must reboot the computer.
DATABASE WRITE ERROR A DOS file write error occurred. Check your CONFIG.SYS file for proper
set up. (FILES=30 and BUFFERS=30).
Verify that no TSR programs are
interfering with APS. If changes are
made, you must reboot the computer.
DECOMPILER BAD MATRIX
DECOMPILER CRC ERROR
A decompiler error occurred. The
message always begins with
DECOMPILER."
Contact your RSI representative.
DESTINATION DIRECTORY CANNOT
BE THE SAME AS A SOURCE
DIRECTORY
The copy to/from directories are the
same.
Change one of the directories and retry
the function.
DESTINATION DIRECTORY MUST BE
SPECIFIED
During copy to, the destination directory
was not specified.
Specify the destination directory and
retry the function.
DISABLE SHORT ADDRESSING TO
ALLOW SELECTION OF WORD/BIT
FOR BINARY FILE
An attempt to change the Binary File
selection to word/bit failed because short
addressing is enabled.
Disable short addressing and then retry.
DOWNLOAD ABORTED During quick edits, when trying to switch
from offline editing to online monitoring,
Ctrl-C was pressed during the download
phase.
The offline ladder editor is displayed.
DUPLICATE NODE ADDRESS Two or more devices on the network
have the same address.
Change the Terminal Address in OnĆline
Configuration. Retry this function.
ENQ RETRIES EXHAUSTED DF1 Full Duplex is not getting a
response from the KF3.
Check for electrical noise problem on
network wiring and retry the function.
ERROR ACCESSING PROCESSOR I/O
CONFIGURATION FILE
Attempt to read the I/O auto
configuration file from the specified 5/03
processor failed.
Make sure the processor is in the
program mode. Retry the function.
ERROR - ALLOCATING SPACE To convert the processor image to a hex
file, the software requests space from
the system. Insufficient space generated
an error.
At the DOS prompt verify that at least
580K of memory exists. Remove any
TSRs that may be taking memory space.
Retry the function.
ERROR - CLOSING ARCHIVE FILE While attempting to close an archive file
an error occurred.
Check your disk space by running
CHKDSK" from your DOS prompt. On
successful completion retry the function.
ERROR - CLOSING HEX FILE While attempting to close a hex file an
error occurred.
Check your disk space by running
CHKDSK" from your DOS prompt. On
successful completion retry the function.