Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 254)

Preface
Advanced Programming Software User Manual
13–4
Using an SLC 5/03 Processor with Channel 1 Configured (DH-485)
The APS version 4.0 and later supports DH-485 point-to-point communication. You
can connect APS to the SLC 500 processors using a 1747-PIC Interface Converter, a
1770-KF3 module, or 1747-KE module. A 1747-AIC Link Coupler is required for
DH-485 network communication.
APS
DHĆ485 Network
SLC 500
Modular I/O Controller
1747-PIC
Interface Converter
APS
FullĆDuplex (PointĆtoĆPoint)
SLC 5/03 CPU
(1747ĆL532)
Channel 0
RSĆ232
Channel 1
DHĆ485
1747ĆCP3
Using an SLC 5/04 Processor with Channel 1 Configured (DH
+
)
The APS version 5.0 and later supports DH
+
communication. Depending on your
system configuration, one of the following interface devices must be used to
communicate over the DH
+
network.
To Connect This Device Use This Interface
IBM Compatible or IBM PS/2
Microchannel Computer
1784ĆKT or 1784ĆKT2 Communication Interface Module
1784ĆKL Communication Interface Module
1784ĆT47 Industrial Terminal 1784ĆKTX Communication Interface Module 1784 T47 Industrial Terminal
1784ĆPCMK Communication Card