Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 150)

Preface
Advanced Programming Software User Manual
8–8
Program File Protection
(SLC 5/03 and SLC 5/04 Processors)
Program file protection is designed to protect your application from having online
edits performed on a program file. The SLC 5/03 and SLC 5/04 processors provide
you with the capability to protect program files on a per file basis. Since the fixed,
SLC 5/01, and SLC 5/02 processors do not support online editing, their protection
status is set to all program files protected.
Program file protection can only be changed during offline programming. Program
file protection is set by selecting the form of protection and then entering a file list
on which to apply the protection. Files can be listed by:
•
separating single file numbers and ranges of files with a delimiter, a comma or
semi-colon. For example 2, 4, 6.
•
specifying ranges of files by separating the beginning and ending file numbers
with a hyphen. For example 2-7.
•
intermixing ranges and individual files. For example 2, 5, 7-10, 250.
Once you have entered the file list, if any errors are detected the cursor is placed at
the position of the error.
The default protection is no program files protected. Additionally, program file
protection cannot be set in a program containing edit zones from an online editing
session. If you press [F10], File Protect for a program containing edit zones, the
message:
PROGRAM CONTAINS EDITS - CANNOT MODIFY PROGRAM
FILE PROTECTION is displayed. For protection to be asserted, you must either
accept or cancel the edit.
To set file protection, do the following:
1. Begin at the main menu and press
CONFIG OFFLINE
CONFIG
OFFLINE
PRG/DOC
F3
, then
CONFIG OFFLINE
CONFIG
PROCSSR
FUNCTS
F1
, then
CONFIG OFFLINE
CONFIG
FILE
PROTECT
F10
. The following display appears: