Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 216)

Preface
Advanced Programming Software User Manual
11–22
2. Press
CONFIG OFFLINE
CONFIG
FULL
DUPLEX
F10
. The following menu is displayed:
F9
Press a function key
SAVE TO
FILE
F1 ACK Timeout 50
F2 NAK Retries 3
F3 ENQ Retries 3
F5 Command Reply Timeout [x55ms] 198
F7 Stop Bits 1
F9 Save to File
FULL Duplex Configuration
F3
ENQ
RETRIES
F5
REPLY
TIMEOUT
ESC exits/Alt-U aborts changes
F1
ACK
TIMEOUT
F2
NAK
RETRIES
F7
STOP
BITS
Function Key Description
[F1] ACK Timeout
Contains a userĆspecified value to count down the amount of
time the sender will wait per transmission attempt for an
acknowledgement before sending an enquiry. Valid multipliers
are 2-65,535. The default selection is 50.
[F2] No Acknowledgement
Retries
Indicates the number of times the sender is not willing to be
acknowledged by the receiver before some sort of error
recovery takes place. Valid entries are 0–255. The default
selection is 3.
[F3] Enquiry Retries
Indicates the number of times the sender will request
reĆtransmission of a response from the receiver. Valid entires
are 0–255. The default selection is 3.
[F5] Command Reply Timeout
Contains a userĆspecified value multiplied by 55 ms to count
down the amount of time the sender will wait for a reply after
the command has been acknowledged. Valid multipliers are
18–25,000. The default selection is 198.
[F7] Stop Bits Toggles between 1 and 2. The default selection is 1.
[F9] Save to File Saves the fullĆduplex parameters to the user file.