Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 209)

Configuring Your Programming Device for Online Communication
11–15
Function Key Description
[F6] Modem Initialize
Allows you to configure the modem using Hayes commands
before the telephone number is dialed. See page 11-16 for
more information.
[F7] Phone Number
Displays the telephone directory where a new number may be
selected or entered. The telephone number is sent
immediately following the initialization. See page 11-17 for
more information.
[F8] Auto Disconnect ➁
Allows you to go offline and return without causing the modem
to reĆdial. If set to zero, the carrier will be dropped as soon as
you go offline. The default is zero. The valid range is 0-60
minutes. See page 11-18 for more information.
[F9] Save to File
Allows you to save the established parameters to a user
configuration file that APS will use to automatically set up
these parameters the next time you use the software.
[F10] Full Duplex Configuration
Displays the fullĆduplex configuration subĆmenu for modifying
system performance parameters.
➀ Function is only available when [F4] Use Modem is set to Yes.
➁ Function is only available when [F5] Dial Phone Number is set to Yes or Yes-And Always Send Init String.
2. Use this table to help you decide your next steps:
If you intend to use fullĆduplex: Do this:
without a modem
1. Configure the first three fields.
2. Select to use no modem by pressing [F4] Use Mode.
Doing this makes function keys [F5], [F6], [F7], and [F8]
unavailable for configuration, since they are a part of
modem support.
3. Configure the fullĆduplex timers and retries by pressing
[F10] Full Duplex Configuration.
with a modem
Configure all of the parameters [F1]-[F10].
The first three function keys are specific to the 1770ĆKF3 or
1747ĆKE interface cards. The parameters must identically
match those set on the cards. The remaining function keys
apply to configuring your system. See the sections that follow
for more information about the functions [F5]-[F8].