Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 405)

APS Error Messages
A–11
Display Message Recommended Action Description
FILE, RUNG, END MCR IS ONLY
ALLOWABLE INSTRUCTION ON RUNG
Rungs containing `end MCR' cannot
contain any other instructions on that
rung. During a program save or test
edits a rung was detected that violates
this rule.
Configure the address for the given
processor and resave the program.
FILE, RUNG, INDEXED O, I, & S
ADDRESSES CURRENTLY ILLEGAL
During program save or test edits, an
indexed input, output, or status file
address was detected where these files
are not allowed.
Change any indexed O, I, S addresses.
FILE, RUNG, SYNTAX ERROR During program save or test edits a rung
was detected to contain invalid
instruction codes or rung structure.
Contact your RSI representative.
FILENAME MUST BE SPECIFIED A file name has not been specified. Specify a file name.
FORCE STATE CANNOT BE MODIFIED
DUE TO FILE FORCE PROTECTION
An attempt was made to force
input/output files that are protected.
Go offline, deselect force protection,
then restore the program.
FUNCTION DISALLOWED This message could mean either 1) you
are not the program owner; 2) the file is
not open for read/write; or 3) the
directory is currently open.
Retry the function.
I/O CONFIGURATION DOES NOT
MATCH PROGRAM
The user program contains references to
unconfigured I/O addresses.
Change the addresses or reconfigure
the I/O.
I/O CONFIGURATION FILES CANNOT
BE MODIFIED DURING ONLINE
EDITING
I/O configuration files cannot be
modified while in the online editing
session.
Go offline and edit; then restore the
program.
ILLEGAL DATA OR PARAMETER
VALUE
The value input is not valid. 1) Check the file number, the file type,
the count, and address being used; 2)
use the WHO function to verify that the
processor maximum node address is ≤
31.
ILLEGAL FILE TYPE During configuration of report options for
the cross reference report an illegal
starting or ending file type was entered.
Enter a valid file type and retry the
function.
ILLEGAL PROGRAM ACCESS
ATTEMPTED
An invalid password was entered for a
password protected file.
Enter a valid password for the specified
file.
ILLEGAL SELECTĆTHE I" RUNG
ATTACHED TO THE SELECTED R"
RUNG CANNOT BE FOUND
During an attempt to perform a
cut/copy/paste, the first rung selected
was marked for replacement.
Contact your local Rockwell Software
representative.
ILLEGAL SIZE An Ext STS error occurred during
communications indicating an illegally
sized communication packet.
Verify that the bridge device is properly
configured.