Rockwell Automation 9323-PA1E USER MANUAL APS 6.0 - Manual (Page 83)

Preface
Advanced Programming Software User Manual
5–16
SOURCE:
DESTIN:
F7 F3
DEFINE
DIR
SELECT
SOURCE
Press a Function Key or Enter File Name
offline SLC 5/03 EXAMPLE
COPY COMMENTS AND SYMBOLS
PROCESSOR
ESC exits
F1
BEGIN
OPER
F4
ENTER
DESTIN
CONVEYOR
DRILL1
EXAMPLE
MIXER
ONOFF
PAINTGUN
RPMCALC
SEQUENCE
STOP_GO
TOGGLE
The window at the right is the directory of Comments and Symbols stored on disk.
The cursor is on
DRILL1 . The window at the left indicates the Source and
Destination of the Comments and Symbols to be copied.
2. Press
CONFIG OFFLINE
CONFIG
SELECT
SOURCE
F3
. This enters DRILL1 as the source.
3. Press
CONFIG OFFLINE
CONFIG
ENTER
DESTIN
F4
. Type: DRILL2 and press [ ENTER ] .
4. Press
CONFIG OFFLINE
CONFIG
BEGIN
OPER
F1
. The file DRILL2 is copied into the directory.
Renaming Archive Files
The procedures for copying and renaming are the same. In the last example, if [F3],
Rename was selected, the comments and symbols would have been deleted from the
processor file
DRILL1 and placed in a separate file name DRILL2 .