Yaskawa 120 Series I/O Modules - Manual (Page 204)

5 Register I/O Specifications
5.2.1 Register Output Modules
5-6
5.2 Register Output Specifications
5.2.1 Register Output Modules - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5-6
5.2.1 Register Output Modules
1) Performance Specifications
This section describes performance specifications, circuit configuration, external
connections, and appearance of the 120-series Register Output Modules.
Item Specifications
Name Register Output Module
Model Name REGISTER-OUT
Model No. JAMSC-120RDO34410
Output Circuit
s
Rated Voltage 12/24 VDC
Allowable Voltage Range 10.2 to 30.0 VDC
Output Form Sinking output
Maximum Load Current Data output circuit: 100 mA per point, 800 mA per 16 points
Select output circuit: 100 mA per point
Output Voltage Drop 1.5V (0.1A) max.
Output Delay Time OFF to ON: 1 ms max.
ON to OFF: 1 ms max.
OFF Leakage Current 1 mA max. (24 VDC)
Output Type Transistor output
Output Protection Type Data output circuit: Protected output (according to JIS B 3502)
Select output circuit: Unprotected output
(according to JIS B 3502)
Built-in Fuse One 1-A fuse
(Blowout time: Two minute max. at 200 % of rated current)
Surge suppressor None
Other Output Protections None
Number of Outputs Data output circuit: 16 points
Select output circuit: 16 points
Output Signal Indication None
External Connections 40-pin connector: one piece
Connector type: FCN-365P040 (made by Fujitsu Ltd.)
Status Indication R: Lights while the Module is operating normally.
ACTIVE: Lights during output processing
F: Lights when the fuse is blown out or the output power supply
is disconnected.
Insulation Method Photocoupler
Dielectric Strength 1,500 VAC for 1 min or 1,800 VAC for 1 s between the output
terminals (connected together) and the internal circuits.
Insulation Resistance 100 M Ω min. at room temperature and humidity between the
output terminals and the ground (measured with a 500 VDC
test voltage megohmmeter).
External Power Supply 12/24 VDC supplied to drive loads
Derating Conditions None
Internal Current Consumption 400 mA max. at 5 VDC