Yaskawa 120 Series I/O Modules - Manual (Page 95)

3.3 I/O Module Cables
3-65
3
3.3.3 W0302 Cables (Model No. JZMSZ-120W0302-††)
1) Use
(1) This Cable is used to connect external devices to the Modules listed below.
(a) 12/24-VDC 32-point Input Module (Model No. JAMSC-120DDI35400)
(b) 12/24-VDC 32-point Output Module (Model No. JAMSC-120DDO35410)
(2) The end of the Cable to the external device is loose wires.
2) Specifications
The following table shows specifications of W0302 Cables.
3) Appearance
The following illustration shows the appearance of a W0302 Cable.
The difference between the W0300 Cable and the W0302 Cable is the size of the end
which connects to the Module Connector.
Table 3.4 Specifications of W0302 Cable
Item Specifications
Model Name W0302-01 W0302-03 W0302-05
Model No. JZMSZ-120W0302-01 JZMSZ-120W0302-03 JZMSZ-120W0302-05
Length L 1.0 m 3.0 m 5.0 m
Cable
Specifications Shielded cable, 40 cores, equivalent to UL20276, AWG24 (0.20 mm 2 )
Cable
Termination Module
side Connector: Connector 10140-6000EL (3M)
Shell 10640-5500-008 (3M)
Screw 3342-26 (3M)
Latch 10600-L0F0-8 (3M)
External
device
side Loose wires: Wire length 150 mm with pin number label on
each wire.
Insulation
Resistance 100 M Ω min. at room temperature and humidity between core wires
(connected together) and shielding wire, and between core wires
(measured with a 500-VDC test voltage megohmmeter).
Connector (Module side)
Model Name
Loose wires (external device side)
A pin number label is on each loose wire
Shielded cable 40-core
loose
wires
150 mm
INFO