Yaskawa 120 Series I/O Modules - Manual (Page 55)

3.2 Digital Output Module Specifications
3-25
3
2) The following diagram shows the circuit configuration.
If using a 100/200-VAC 8-point Output Module, connect a fuse, which complies with
the load specifications, in series with the load.
A protective fuse does not built into the following 100/200-VAC 8-point Output
Modules. If a fuse is not connected, fire or damage to the devices or output cir-
cuits may occur if the load is short-circuited or the circuit overloaded.
Insulation Resistance 100 M Ω min. at room temperature and humidity between input termi-
nals and ground
(measured with a 500-VDC test voltage megohmmeter).
External Power Supply 100/200 VAC supplied to drive loads
Derating Conditions None
Internal Current Consumption 50 mA max. at 5 VDC (with all points ON)
Maximum Heating Value 9.0 W
Hot Swapping
(Removal/insertion under power) Permitted
Approx. Mass 300 g
External Dimensions 40.3 ×130×103.9 mm (W×H×D)
Item Specifications
Output 1
Output 8
100/200 VAC
100/200 VAC
Output signal
indicator
From CPU
Phototriac
Internal circuits
CAUTION