Yaskawa 120 Series I/O Modules - Manual (Page 297)

8 EN Standard Low voltage Directive Compliant I/O Modules
8.1.4 Specifications of the I/O Modules
8-10
4) 100- to 120-VAC or 200- to 240-VAC 8-point Output Modules
Table 8.5 Specifications of 100- to 120-VAC or 200- to 240-VAC 8-point Output Modules
Item Specifications
Name 100- to 120-VAC or 200- to 240-VAC 8-point Output Module
Model Name ACOUT-8P
Model No. JAMSC-120DAO83009 (EN standard)
Rated Voltage 100 to 120 VAC or 200 to 240 VAC
Allowable Voltage Range 80 to 264 VAC
Rated Frequency 50/60 Hz
Allowable Frequency Range 47 to 63 Hz
Maximum Load Current 1.0 A rms/point
Output Voltage Drop 1.0 V rms
Output Delay Times OFF to ON: 5ms max.
ON to OFF: 1/2 cycle + 5 ms max.
OFF Leakage Current 3 mA max. at 240 VAC, 50 Hz
Minimum Load Current 10 mA rms
Output Type Triac outputs
Number of Commons 8 (Each output circuit is independent.)
Output Power Supply per Common Different phase power supplies can be connected to the commons.
External Connections Removable terminal block with M3 screw terminals.
Output Protection Type Unprotected outputs (according to IEC 1131-2)
Built-in Fuse None
Surge Suppressor Varistor
Other Output Protections None
Number of Outputs 8
Output Signal Indication Indicator for each point; lit when the output is ON.
Status saved in internal logic
Status Indication ACTIVE: Lit during output processing
Insulation Method Phototriac
Dielectric Strength 1,500 VAC for 1 min. or 1,800 VAC for 1 s between output terminals
and internal circuits and between all output circuits.
Insulation Resistance 100 M Ω min. at room temperature and humidity between output ter-
minals and ground (measure by a 500-VDC test voltage megohm-
meter)
External Power Supply 100 to 120 VAC or 200 to 240 VAC to drive loads
Derating Conditions None
Internal Current Consumption 150 mA max. at 5 VDC (with all points ON)
Hot Swapping
(Removal/insertion under power) Permitted
Maximum Heating Value 9.0W
Approximate Mass 300g
External Dimensions 40.3 ×130×103.9 mm (W×H×D)