Yaskawa 120 Series I/O Modules - Manual (Page 295)

8 EN Standard Low voltage Directive Compliant I/O Modules
8.1.4 Specifications of the I/O Modules
8-8
2) 200- to 240-VAC 16-point Input Modules
Table 8.3 Specifications of 200- to 240-VAC 16-point Input Modules
Item Specifications
Name 200- to 240-VAC 16-point Input Module
Model Name AC200IN-16P
Model No. JAMSC-120DAI74309 (EN standard)
Rated Voltage 200 to 240 VAC
Maximum Allowable Voltage 264 VAC
Rated Frequency 50/60 Hz
Allowable Frequency Range 47 to 63 Hz
Inrush Current 320 mA
Rated Current 7 mA (at 200 VAC, 50 Hz)
Input Impedance 28.6 k Ω (at 200 VAC, 50 Hz)
23.1 k Ω (at 200 VAC, 60 Hz)
Standard Operating Ranges ON voltage range: 159 to 264 VAC
OFF voltage range: 40 VAC max.
Input Type AC type 2 (according to IEC 1131-2)
Input Delay Times OFF to ON: 20 ms max.
ON to OFF: 35 ms max.
Number of Commons 2
Number of Inputs per Common 8 points/common
Input Power Supply per Common Connect power supplies of the same phases to the common 1 and
common 2.
External Connections Removable terminal block with M3 screw terminals.
Number of Inputs 16
Input Signal Indication Indicator for each point; lit when the input is ON.
Status saved in internal logic
Status Indication ACTIVE: Lit during input processing
Insulation Method Photocoupler
Dielectric Strength 1,500 VAC for 1 min. or 1,800 VAC for 1 s between input terminals
and internal circuits and between all input commons
Insulation Resistance 100 M Ω min. at room temperature and humidity between input ter-
minals and ground (measure by a 500-VDC test voltage megohm-
meter)
External Power Supply 200 to 240 VAC supplied to signals
Derating Conditions None
Internal Current Consumption 90 mA max. at 5 VDC (with all points ON)
Hot Swapping (Removal/insertion
under power) Permitted
Maximum Heating Value 3.5 W
Approximate Mass 250 g
External Dimensions 40.3 ×130×103.9 mm (W×H×D)