Yaskawa 120 Series I/O Modules - Manual (Page 232)

6.1 Installing Modules
6-5
6
Install the Module with Terminal Blocks on the Mounting Base in the following man-
ner.
a) Remove the cover from the Module connector on the Mounting Base.
b) Loosen the terminal block mounting screws, then remove the terminal block from the
Module.
c) Install the Module on the Mounting Base as shown below.
(1) Hook the Module to the Module hook on the Mounting Base.
Module hook
Module connector
Terminal block mounting screw
Terminal block
mounting screw
Terminal block
Module
Module
Module hook
Module
connector
Mounting Base