Yaskawa Sigma II Series DC Power Input SGMAJ - Manual (Page 147)

7.1 Functions on Digital Operator
7-3
7
7.1.2 Key Names and Functions
Key names and functions for the digital operator and the panel operator are explained below.
Set parameters and JOG operation, and display status using the panel operator.
When an alarm occurs, remove the cause, and then reset the alarm. Refer to 10.1 Troubleshooting.
Key Function
To reset the servo alarm.
Note 1. The servo alarm can be reset by /ALM-RST (CN1-18) input signal.
2. The servo alarm need not be reset if the control power supply is turned OFF.
To select a basic mode, such as the status display mode, utility function mode, parameter
setting mode, or monitor mode.
Can be also used to set the data.
To display parameter setting and set value.
Press the UP Key to increase the set value.
For JOG operation, this key is used as Forward Run Start Key.
Press the DOWN Key to decrease the set value.
For JOG operation, this key is used as Reserve Run Start Key.
Press the RIGHT Key to shift to the next digit on the right.
Press the LEFT Key to shift to the next digit on the left.
Press the SVON Key to perform servo ON/OFF in the JOG operation with the operator.
Hand-held
Digital Operator
ALARM
SERVOPACK
DIGITAL
OPERATOR
JUSP-OP02A
RESET
DSPL
SET
JOG
SVON
DATA
ENTER
YASKAWA
ALARM
RESET
(RESET Key)
DSPL
SET
(DSPL/SET Key)
DATA
ENTER
(DATA/ENTER Key)
(UP Key)
(DOWN Key)
(RIGHT Key)
(LEFT Key)
JOG
SVON
(SVON Key)
IMPORTANT