Yaskawa Sigma II Series DC Power Input SGMAJ - Manual (Page 171)

7.4 Operation in Monitor Mode (Un†††)
7-27
7
(2) Sequence I/O Signal Monitor Display
The following section describes the monitor display for sequence I/O signals.
(a) Input Signal Monitor Display
The status of input signal allocated to each input terminal is displayed:
When the input is in OFF (open) status, the top segment (LED) is lit.
when the input is in ON (short-circuited) status, the bottom segment (LED) is lit.
Refer to 7.3.2 Input Circuit Signal Allocation for the relation between input terminals and signals.
* When using SGDJ-†††P SERVOPACK for the position control mode, the SEN signal is
assigned Pin No.36.
• When /S-ON signal is ON (Servo ON at L level)
• When /S-ON signal is OFF
• When P-OT signal operates (Operates at H level)
7 6 5 4 3 2 1
Top: OFF (H level)
Bottom: ON (L level)
Number 8
Display LED
Number
Input Terminal Name Factory Setting
1 CN1-14 /S-ON
2 CN1-15 /P-CON
3 CN1-16 P-OT
4 CN1-17 N-OT
5 CN1-18 /ALM-RST
6 CN1-11 /P-CL
7 CN1-12 /N-CL
8 CN1-5 (36)* SEN
EXAMPLE
The bottom segment
of number 1 is lit.
7 6 5 4 3 2 1 8
7 6 5 4 3 2 1 8
The top segment of
number 1 is lit.
The top segment of
number 3 is lit.
7 6 5 4 3 2 1 8