Yaskawa Sigma II Series DC Power Input SGMAJ - Manual (Page 325)

10 Inspection, Maintenance, and Troubleshooting
10.4.2 List of Parameters
10-44
Pn50D Input Signal Selections 4 − − 8888 8888 After
restart
−
Parame-
ter No.
Name Setting Range Units Factory Setting Setting
Validation
Reference
Section
††† S †††P
0
1
2
3
0 to F Same as /ZCLAMP
Same as /ZCLAMP
ON when CN1-14 input signal is ON (L-level).
ON when CN1-15 input signal is ON (L-level).
ON when CN1-16 input signal is ON (L-level).
ON when CN1-17 input signal is ON (L-level).
ON when CN1-18 input signal is ON (L-level).
ON when CN1-11 input signal is ON (L-level).
ON when CN1-14 input signal is OFF (H-level).
ON when CN1-15 input signal is OFF (H-level).
ON when CN1-16 input signal is OFF (H-level).
ON when CN1-17 input signal is OFF (H-level).
ON when CN1-18 input signal is OFF (H-level).
ON when CN1-11 input signal is OFF (H-level).
ON when CN1-12 input signal is OFF (H-level).
ON when CN1-12 input signal is ON (L-level).
/ZCLAMP Signal Mapping (Zero clamp when ON (L-level))
(Refer to "8.5.6 Using the Zero Clamp Function.")
/INHIBIT Signal Mapping (Reference pulse inhibit when ON (L-level))
(Refer to "8.6.7 Reference Pulse Inhibit Function (INHIBIT).")
/G-SEL Signal Mapping (Gain change when ON (L-level))
(Refer to "9.4.8 Switching Gain Settings.")
Reserved (Do not change)
4th
digit
3rd
digit
2nd
digit
1st
digit
n.
0 to F
4
5
6
7
8
9
A
B
C
D
E
F
Sets signal OFF.
Sets signal ON.