Yaskawa Sigma II Series DC Power Input SGMAJ - Manual (Page 324)

10.4 List of Parameters
10-43
10
Parame-
ter No.
Name Setting Range Units Factory Setting Setting
Validation
Reference
Section
††† S †††P
Pn50C Input Signal Selections 3 − − 8888 8888 After
restart
−
0
1
2
3
4
5
6
7
8
9
A
B
ON when CN1-14 input signal is ON (L-level).
ON when CN1-15 input signal is ON (L-level).
ON when CN1-16 input signal is ON (L-level).
ON when CN1-17 input signal is ON (L-level).
ON when CN1-18 input signal is ON (L-level).
ON when CN1-11 input signal is ON (L-level).
ON when CN1-12 input signal is ON (L-level).
Sets signal ON.
Sets signal OFF.
ON when CN1-14 input signal is OFF (H-level).
ON when CN1-15 input signal is OFF (H-level).
ON when CN1-16 input signal is OFF (H-level).
ON when CN1-17 input signal is OFF (H-level).
0 to F Same as /SPD-D
0 to F Same as /SPD-D
4th
digit
3rd
digit
2nd
digit
1st
digit
n.
ON when CN1-18 input signal is OFF (H-level).
ON when CN1-11 input signal is OFF (H-level).
ON when CN1-12 input signal is OFF (H-level).
C
D
E
F
0 to F Same as /SPD-D
/SPD-D Signal Mapping
(Refer to "8.8 Operating Using Speed Control with an Internally Set Speed.")
/SPD-A Signal Mapping
(Refer to "8.8 Operating Using Speed Control with an Internally Set Speed.")
/SPD-B Signal Mapping
(Refer to "8.8 Operating Using Speed Control with an Internally Set Speed.")
/C-SEL Signal Mapping (Control mode change when ON (L-level))
(Refer to "8.10.2 Switching the Control Mode.")