Microsoft Surface Hub 2 SmCamera User Manual
Page 127
Action
Where
Notes
Check Wi-
Fi is
turned on
Surface Hub
- Open
Settings > View as Admin
. Select
Network & Internet
and
make sure
Wi-Fi
is turned
On
.
Note
: Surface Hub doesn't need to be connected to a wireless
network, but Wi-Fi must be enabled for Miracast to work.
Verify
Miracast
projection
is turned
on
Surface Hub
1. Open
Settings > View as Admin
. Select Surface Hub> Projection.
2. Make sure the following settings are turned on:
-
Connect automatically when someone projects
-
Presenters can use Miracast to protect wirelessly to this device
Note:
If a PIN is required, users must enter it when they connect an
external device for the first time.
Verify
Miracast
support
External
device
1. Press
Windows logo key
+
R
and type
dxdiag
.
2. Select
Save all information.
3. Open the saved
dxdiag.txt
file and find
Miracast
. It should
indicate
Available, with HDCP
.
Check
Miracast
channel
Surface Hub
If you run a network scan, you should see Surface Hub Miracast
listed as an access point. If Surface Hub's Miracast network appears,
but you can't see it as an available device, try to adjust the Miracast
channel.
When Surface Hub is connected to a Wi-Fi network, it uses the
same channel settings as the Wi-Fi access point for its Miracast
access point. For troubleshooting purposes, disconnect Surface
Hub from any Wi-Fi networks (but keep Wi-Fi enabled), so you can
control the channel used for Miracast. You can manually select the
Miracast channel in Settings. You'll need to restart Surface Hub
after each change. Use channels that don't show heavy utilization
from the network scan.
Check
drivers
External
device
Ensure the device drivers on your external device are up to date
and the latest firmware is installed for your wireless display or
adapter. In
Device Manager
, select
Network Adapters
, open the
Wi-Fi adapter and video adapter and check for an updated driver
version.
Check
firewall
External
device
The Windows firewall can block Miracast traffic. The most
straightforward test is to disable the firewall and test projection. If
Miracast works with the firewall disabled, add an exception for:
- C:\Windows\System32\WUDFHost.exe
- Allow In/Out connections for TCP and UDP, Ports: All.