Microsoft Surface Hub 2 SmCamera - Manual (Page 433)

10. Lift plywood end piece up and back.
11. Remove bump label from back.
12. Lift the Hub 2S from the lower tray and place on cart or wall mount.
13. Loosen elastic tension clips (x2).
14. Remove cloth cover.
Ｕ Caution
Do not leave Hub 2S 85" unattended. An additional person is needed to hold
device upright. Once end pieces are removed, a minimum of one person
needs to maintain contact with the Hub 2S until placement on wall mount or
cart is completed.
７ Note
Following the cart or wall mount manufactures instructions, prepare the
mounting system prior to removing the Hub 2S from its inner packaging tray.
 Tip
When grasping the Hub 2S, note the hand hold cut outs in the lower foam.
Care must be taken care with the top hand not to grasp the device where the
speakers are located. Graphic on the ends of the device cover provide general
speaker location.