Microsoft Surface Hub 2 SmCamera - Manual (Page 215)

Surface Hub 2S camera lens orientation
Article • 05/11/2023
Surface Hub 2S comes with an external camera accessory that can be mounted to any of
the four (4) USB-C ports on the bezel of the display. It is recommended to place the
camera on the top center of the display to provide the widest field of view for remote
meeting participants.
Applies to: Surface Hub 2S - 50 inch
Original KB number: 4509729
By default, the camera lens orientation is configured for top mounting but if a customer
chooses to side mount, the camera lens orientation will need to be manually rotated.
This rotation can be achieved by the following steps:
1. Power off the Surface Hub 2S, then unmount the Camera from the display by
gently tilting the camera body towards the front of the display until it detaches.
2. Locate the camera orientation driver pin on the bottom of the camera body. Use a
2mm hex key to rotate the driver pin one full turn, until you feel the driver pin
stop.
Summary
７ Note
You should hear the camera lens rotate when it flips to the new orientation. Be
careful not to force or over rotate the lens.