Microsoft Surface Hub 2 SmCamera - Manual (Page 176)

power cord again, the device should boot after a few seconds. Then you'll see the
white logo in the middle of screen.
If the device doesn't turn on, press and release the power button. Immediately
after you see the logo in the middle of the screen, press and hold the Volume
down button until you see the spinning circle below the white logo.
3. When the out-of-box experience (OOBE) setup starts, follow the instructions to
install Windows 10/11 Pro or Enterprise (version 20H2 or later).
To ensure that your Surface Hub 2 is up to date, install drivers and firmware for
Windows 10 Pro and Enterprise . Then reboot the device. Keep the Surface turned on
for an hour, and then reboot it again. You won't be prompted for the second reboot.
This pause and extra reboot ensures that the firmware has been fully updated.
To configure Surface Hub 2S as a personal productivity device, see Configure Windows
10/11 Pro or Enterprise on Surface Hub 2 .
If you want to restore your device to Windows 10 Team, see Reset and recovery for
Surface Hub 2S . Before you roll back to Windows 10 Team, we recommend that you first
unenroll the Surface Hub from SEMM. To learn more, see Unenroll Surface devices from
SEMM .
Install Surface Hub 2 drivers and firmware
Configure recommended settings
７ Note
If you can't successfully migrate your device to Windows 10/11 Pro or Enterprise for
Surface Hub 2 by following the steps outlined in this article, contact
Surface Hub
Support .
To roll back to Windows 10 Team
２ Warning