Microsoft Surface Hub 2 SmCamera - Manual (Page 158)

1. On your Surface Hub 2S, sign in as Admin .
2. Go to All apps > Settings > Update and Security > Windows Update , and install
all updates.
3. Restart the device.
4. Verify the UEFI version by using the Surface app. If the UEFI version isn't version
694.2938.768.0 or later, repeat these steps, or use the following procedure to get
the latest UEFI version.
1. Go to the Surface recovery site and select Surface Hub 2S .
2. Enter your Hub serial number. It's located on the back of the Hub next to the
power connection.
3. Follow the directions to download the image onto a formatted USB drive by
installing the Windows 10 Team 2020 Update.
4. After the update, the device enters out-of-box-experience (OOBE) setup. You don't
need to complete setup. The UEFI version is already updated. Instead power down
the device by holding the power button until the screen turns off.
On a separate PC, follow these steps:
1. On the Surface Tools for IT page , select Download .
2. Select and download the Surface UEFI Configurator MSI file, and install it on a
separate PC. The Surface UEFI Configurator tool can't be run on a Surface Hub 2S
while Windows 10 Team edition is installed.
3. Download the Surface Hub 2 drivers and firmware Windows Installer MSI file .
You'll use this file when you install the new operating system.
７ Note
If you don't know your user name or admin password, you'll need to reset the
device. For more information, see
Reset and recovery for Surface Hub 2S .
Update the UEFI via bare metal recovery (BMR) image
Download Surface UEFI Configurator and Surface Hub 2
drivers and firmware