Yaskawa AC Drive Z1000 Bypass Technical Manual - Manual (Page 28)

1.3 Model Numbers and Nameplate Checks
Please perform the following tasks after receiving the Z1000 Bypass
• Inspect the Z1000 Bypass for damage.
If the Z1000 Bypass appears damaged upon receipt, contact the shipper immediately.
• Verify receipt of the correct model by checking the information on the nameplate.
• If you have received the wrong model or the Z1000 Bypass does not function properly, contact your supplier.
If you find any irregularities in the above items, contact the shipping company, the distributor or representative you purchased
the Z1000 Bypass from or your Yaskawa office immediately. The Z1000 Bypass is thoroughly tested at the factory. Any
damages or shortages evident when the equipment is received must be reported immediately to the commercial carrier that
transported the material. Shipping damage is not covered by the Yaskawa warranty. After unpacking and inspecting for damage,
verify that internal wire connections have not come loose during shipment by spot checking wire terminations with a
screwdriver or the appropriate tool. Z1000 Bypass storage must be in a clean and dry location. Maintain the factory packaging
and provide covering as needed to protect the Z1000 Bypass from construction site dirt, water, debris and traffic prior to and
during construction.
u Drive Nameplate
F
E
D
C
B
A
A – Software version
B – Serial number
C – Lot number D – Output specifications
E – Input specifications
F – AC drive model
Figure 1.1 Drive Nameplate Information Example
CIMR - Z U 2 A 0021 F A A
Drive Z1000
Series
No.
Enclosure
Type
Design
Revision
Order
No.
Customized
Specifications
A Standard model
No.
Region
Code
U USA
IP00/
Open-Type
F
IP20/
NEMA
Type 1
A
No. Voltage Class
No.
Environmental
Specification
A Standard
3-phase, 200-240 Vac 2
3-phase, 380-480 Vac 4
No. Drive Model
Amp Rating
1.3 Model Numbers and Nameplate Checks
28 YASKAWA ELECTRIC SIEP YAIZ1B 01D YASKAWA AC Drive – Z1000 Bypass Technical Manual