Yaskawa AC Drive Z1000 Bypass Technical Manual User Manual
Page 79
n
Reattaching the Front Cover
Drives Mounted on Z1000 Bypass Models Z1B1D002 to D114 and B001 to B096
Reverse the instructions given in Removing the Front Cover (Drives Mounted on Z1000 Bypass Models Z1B1D002 to D059
and B001 to B52L) on page
and Removing the Front Cover (Drives Mounted on Z1000 Bypass Models Z1B1D074 to
D114 and B052 to B096) on page
to reattach the front cover. Pinch inwards on the hooks found on each side of the front
cover while guiding it back into the drive. Make sure it clicks firmly into place.
Power lines and signal wiring should pass through the opening provided.
Reattach the front cover after completing the wiring to the drive and other devices.
Figure 3.31 Reattach the Front Cover (Models Z1B1D002 to D114 and B001 to B096)
Drives Mounted on Z1000 Bypass Models Z1B1D143 to D273 and B124 to B302
1.
Slide the front cover so the hooks on the top connect to the drive.
Figure 3.32 Reattach the Front Cover (Models Z1B1D143 to D273 and B124 to B302)
2.
After connecting the hooks to the drive, press firmly on the cover to lock it into place.
3.5 Control Circuit Wiring
YASKAWA ELECTRIC SIEP YAIZ1B 01D YASKAWA AC Drive – Z1000 Bypass Technical Manual
79
3
Electrical Installation