Metrohm tiamo 2.3 (process analysis) - Manual (Page 1003)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 987
Designation Description
.LP.MEA Measured value (temperature) for the last measuring
point in the unit of the measured value of the measur-
ing point list
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.MA.MEA Maximum measured value (temperature) in the unit of
the measured value
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MI.MEA Minimum measured value (temperature) in the unit of
the measured value
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
5.6.4.7.2 MEAS T - General/Hardware
Tab: Method ▶ MEAS T ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device, the sensor and the stirrer are
defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined